Handphone stand

LASER CUTTING

For my handphone stand design, I wanted to go with something cool and interesting but after researching and thinking for a bit, I had decided to do a clean and sleek hand phone stand with a print/etch/design on the back.

this is the design I will be going for.

Its simple and clean and can I can easily add a design at the back.

Now onto actually making the handphone stand. The first step is the easiest, press sketch and draw a simple line of 80mm

The second step is to roughly draw a line like this. For now we don't need to worry about the specific of the angles and lengths too much as we will be adjusting that later on.

The third step is to do roughly the same thing just that this line is specified to be 70mm.

The fourth step is where we start to get specific but don't worry, we will be taking it slow and easy. For this step, we will use sketch dimensions and select the lines drawn in the second and third step and adjust the angle in between them to be 40 degrees as shown.

The fifth step is to add a 20 cm line and 15 cm line as shown in the photo

Next we extrude symmetrically by pressing extrude and the following panel will be shown. Press the direction and change it to symmetric and extrude it by 40 mm

After extruding the sketch, you should get something like this

Next is to round of the sharp corners of the handphone stand so for this we will use fillet. After filleting all the corners, we should get something like this.

Lastly we can put the design we want onto the back of the handphone stand. The design I will put on the logo that I want on the back. In this case it is the logo of my favourite superhero which is the flash